
Assessment OICEW-4-1B
Watch Relief
Assessed in EN-4231 Sea Term IV: Marine Engineering
Pre-watch debrief
Prior to taking over the engineering watch, relieving officers shall satisfy themselves regarding at least the following:
The standing orders and special instructions of the chief engineer officer relating to the operation of the ship's systems and machinery; |
|
The nature of all work being performed on machinery and systems, the personnel involved and potential hazards; |
|
The level and, where applicable, the condition of water or residues in bilges, ballast tanks slop tanks, reserve tanks, fresh water tanks, sewage tanks and any special requirements for use or disposal of the contents thereof; |
|
The condition and level of fuel in the reserve tanks, settling tank, day tank, and other storage facilities; |
|
Any special requirements relating to sanitary system disposals; |
|
Condition and mode of operation of the various main and auxiliary systems, including the electrical distribution system; |
|
Where, applicable, the condition of monitoring and control console equipment, and which equipment is being operated manually; |
|
Where applicable, the condition and mode of operation of automatic boiler controls such as flame safeguard control systems, limit control systems, combustion control systems, fuel-supply control systems and other equipment related to the operation of steam boilers; |
|
Any potentially adverse conditions resulting from bad weather, ice, or contaminated shallow water; |
|
Any special modes of operation dictated by equipment failure or adverse ship conditions; |
Is any machinery or controls out of service or in hand mode? Is there anything unusual about this watch? |
The reports of engine-room ratings relating to their assigned duties; |
|
The availability of fire-fighting appliances; and |
|
The state of completion of the engine-room log. |
|
Condition
Aboard ship while underway, or in an approved simulator, given the engineering log book, the pertinent standing orders and proper safety equipment.
Performance Requirements
Behavior | Standard |
---|---|
The student will: | During assessment, the student shall, at a minimum: |
Check engine room and machinery in accordance with stcw code (a-vii/2 part 3-2 ยง58) |
|
Check that all members of the relieving watch are ready to perform their duties |
Insure:
|
Relieve the watch |
Clearly indicate when watchstanding responsibility is assumed |
Supports Table A-III/1 officers in charge of an engineering watch
Competence | Knowledge, Understanding & Proficiency | Task |
---|---|---|
Maintain a safe engineering watch |
A1.1 Thorough knowledge of Principles to be observed in keeping an engineering watch, including:
|
Watch Relief |