Assessment OICEW-5-1J
Prepare main propulsion diesel engine for operation
Assessed in EN-4131 Internal Combustion Engines II
Condition
In an approved simulator, in the laboratory, or aboard a ship and given access a main propulsion diesel engine.
| Behavior |
Standard |
| The student will: |
During assessment, the student shall, at a minimum: |
|
Line Up and Start seawater system
|
Check:
- pump is operating
- saltwater temperature control on automatic
- saltwater pump control on automatic
|
|
Line up and Start low temperature freshwater cooling system
|
Check:
- verify cooling supply to operating equipment
- LTFW temperature control on automatic
- LTFW pump control on automatic
|
|
Line up and Start piston cooling system
|
Check:
- piston cooling tank level
- cooling water temperature, heat if necessary
|
|
Line up and Start high temperature freshwater cooling system
|
Check:
- verify cooling supply to operating equipment
- htfw temperature control on automatic
- htfw pump control on automatic
|
|
Line up and Start injector cooling system
|
Check:
- injector coolant expansion tank level
- injector coolant temperature
- pump on auto
- secure heating when temperature reaches 60°c
|
|
Line up and Start main lube oil system
|
Check:
- sufficient sump level
- oil temperature, heat if necessary
- cylinder day tank filled
- lube oil cooler lined up
- oil temperature control on auto
- standby pump on auto
- crosshead pump running
|
|
Line up and Start stern tube lube oil system
|
Check:
- tank level
- pumps running on auto
Select upper or lower tank based on draft
|
|
Start turning gear
|
Prior to starting, check:
- lube oil system is running
- blocking valve shut
- indicator cocks open
Obtain wheel clearance
Start turning gear
|
|
Line up and Start main fuel oil system
|
Bypass fuel oil meter while warming up
Heat oil if necessary
Viscosity control on auto
Start fuel booster pump
|
|
Line up start air system
|
Check pressure available
Drain cooler and receiver
Align system
|
|
Secure turning gear
|
Stop motor
Disengage turning gear
|
Supports Table A-III/1 officers in charge of an engineering watch
| Competence |
Knowledge, Understanding & Proficiency |
Task |
|
Operate main and auxiliary machinery and associated control systems
|
A4.1
Basic construction and operation principles of machinery systems, including:
- marine diesel engine
- marine steam turbine
- marine gas turbine
- marine boiler
- shafting installations, including propeller
- other auxiliaries, including various pumps, air compressor, purifier, fresh water generator, heat exchanger, refrigeration, air-conditioning and ventilation systems
- steering gear
- automatic control systems
- fluid flow and characteristics of lubricating oil, fuel oil and cooling systems
- deck machinery
|
Prepare main propulsion diesel engine for operation
|
Published: 2016-10-28-04:00