Assessment OICEW-2-1C

External thread using a hand die

Assessed in ST-0999E Sea Term I (Engineering Portion)

Condition

In a workshop/laboratory or other safe working environment, given a hand die, proper tools, lighting, ventilation, and steel round stock or pipe of no less than 3/8 inch diameter.

Performance Requirements

Behavior	Standard
The student will:	During assessment, the student shall, at a minimum:
Plan to make an external thread on 1/2" pipe
Use tools to Fabricate an external thread on the 1/2" pipe with the axis of the pipe and thread co-linear	Use: tape measure pipe cutter pipe reamer cutting oil 1/2" hand pipe die

Behavior

Standard

The student will:

During assessment, the student shall, at a minimum:

Plan to make an external thread on 1/2" pipe

Use tools to Fabricate an external thread on the 1/2" pipe with the axis of the pipe and thread co-linear

Use:

tape measure
pipe cutter
pipe reamer
cutting oil
1/2" hand pipe die

Attachment:

Supports Table A-III/1 officers in charge of an engineering watch

Competence	Knowledge, Understanding & Proficiency	Task
Appropriate use of hand tools, machine tools and measuring instruments for fabrication and repair on board	C1.6 Use of hand tools, machine tools and measuring instruments	External thread using a hand die

Published: 2016-10-28-04:00