Assessment OICEW-1-1B
Form two steel plates using brazing process
Assessed in EN-2112 Machine Tool Technology
Condition
In a workshop/laboratory or other safe working environment, given proper tools, lighting, ventilation, and two steel plates of no less than 1/8 inch thickness.
Performance Requirements
| Behavior | Standard |
|---|---|
| The student will: | During assessment, the student shall, at a minimum: |
|
Use Tools to perform brazing process |
Observe all personal and environmental safety procedures Select brazing material, flux, and tip size appropriate for the job Prepare and clean plates Adjust torch for neutral flame Preheat plates Braze according to standard brazing procedure |
Supports Table A-III/1 officers in charge of an engineering watch
| Competence | Knowledge, Understanding & Proficiency | Task |
|---|---|---|
|
Appropriate use of hand tools, machine tools and measuring instruments for fabrication and repair on board |
C1.6 Use of hand tools, machine tools and measuring instruments |
Form two steel plates using brazing process |
Published: 2016-10-28-04:00