OICEW-5-1D

Start and secure air compressor

Using an approved simulator, in the laboratory, or aboard ship and given access to an air compressor.

Behavior	Standard
The student will:	During assessment, the student shall, at a minimum:
Check unit for readiness to start	Inspect mechanical condition of equipment Observe sufficient lubricating oil Blow down receiver and moisture traps On water cooled units, verify coolant flow
Line-up compressor	Verify compressor discharge valve is open
Start compressor	press start button verify control set to automatic
Monitor operation of air compressor	Verify operation of unloader Verify operation of cut-in and cut-out switches
Secure the air compressor	Press the stop button Leave compressor lined up to start

See the Engineering Assessment Guidelines for additional specifications of behavior and standards.

Note: This assessment supports KUP OICEW-A4.1, and is assessed in EN-2111 Auxiliary Machinery II.