OICNW-1-6A

Steering gear test

Condition

On a vessel or a full mission ship simulator.

Performance requirement

Behavior Standard
The student will: During assessment, the student shall, at a minimum:

Conduct the pre-departure test of the vessel’s steering gear.
  1. The steering control system is turned on.
  2. The steering gyro repeater is aligned with the master gyro-compass.
  3. After the required warm up period, the controls for switching pumps and motors between the port and starboard steering systems are tested.
  4. Both port and starboard steering systems are tested as follows:
    1. When the control is switched to hand steering, the rudder is tested throughout its full range of motion.
    2. When the control is switched to non follow-up, the rudder is tested throughout its full range of motion.
  5. Change the steering mode from auto plot to hand and back.

or MT-3372. Shall be completed by the end of MT-4371.

Note: This assessment supports KUP OICNW-A1.08, and is assessed in MT-4371 Sea Term IV: Marine Transportation.