The following are the tools and equipment recommended for all engineering cadet participating on the training cruise.

Fourth Class

• Two cell flashlights, D-Cell preferred, plastic case. (No Mini Maglights)
• Safety glasses
• Hard Hat or Bump Cap
• Leather work gloves
• 10" Crescent Wrench
• 4" Flat blade screwdriver
• Jackknife

• Tool box
• 12" Pipe wrench
• 6" Flat blade screwdriver
• 4" Phillips screwdriver
• 6' Tape measure
• Side cutter pliers
• Socket set, 3/8" drive, 1/4" to 3/4" sockets
• Combination wrench set, 3/8" to 1"
• Packing pullers
• Multitester (inexpensive)
• Hacksaw
• Feeler gage
• Slip joint pliers (channel-locks)
• Small fuse puller

• Allen wrench set to 1/4"
• Ballpeen hammer 16 oz.
• Drift pin set
• Small wire brush
• 6" Vernier caliper
• Needle nose pliers
• Vise Grips
• Cold chisel 3/8"
• Drill index 1/16 to 3/8"

Engineering Rates All tool previously mentions plus:

• 1/2" Drive socket set
• Flat blade and Phillips screwdrivers
• Open end box combination wrench set to 1"
• 6" Steel rule
• 8" Crescent wrench
• File-fine cut
• Ball peen hammer-12oz.
• Side cutting pliers
• Packing knife
• Cutting Goggles (Optional)

• Principles of Naval Engineering
• Empire State Engineering Training Manual if issued last year.
• Marine Engineering Workbook, 1/c only.

Miscellaneous Equipment

• Steel Toed Shoes.
• Boiler Suit.
• D-cell Flashlight.
• Hearing Protection.
• Khaki Shirt for Engine room use for 1/c and 2/c.